To create a shower floor from scratch we use what is commonly referred to as “dry pack mortar” or deck mud. Deck mud contains three ingredients: regular portland cement, sand, and water. That’s it. Don’t let anyone tell you that a latex additive or anything else is necessary. It is not. Properly mixing and installing deck mud will create a shower floor that will last for years and years.

The ratio is very important to achieve the correct consistency and stability. You want 5 parts sand to 1 part cement. Your ratio can vary from 4 to 6 : 1 but the 5 : 1 is what I use and find to be the easiest to work. You want just enough water to dampen the mixture. It’s not a lot. Too much water will cause your mud to shrink as it cures and compromise the stability of your base. You just want it damp – really.

The easiest and most convenient way to get your mixture correct is to buy the quikrete “sand and topping” mix which is sold at all the big home centers. This is already mixed at a 3 : 1 ratio. For a 60lb. bag you need only add 30lbs. of sand to it. This is how I mix mine – it’s convenient. The easiest way to mix it is with a regular shovel or garden hoe in a mixing box or regular wheelbarrow, although you can mix it with and in anything that works for you.

After it’s mixed it should just be damp. When you pick up a handful of it you should be able to squeeze it without water dripping from it. It should be able to hold it’s shape when you squeeze it, just like a snowball.

Whether you mix the entire batch from scratch or use the sand and topping mix it should all have this same consistency. If it is any wetter it will shrink as it dries and it will not be as solid and stable as it should be. I usually start with about 1/2 gallon of water and work up from there. I think. I really can’t tell you exactly how much water to use because I don’t measure it. I’ll have to do that and include it here.

As you install and shape your base, slopes, and shower floors you want to pound the mix with a wooden or magnesium float. I mean beat the hell out of it. You want the mud packed very well with no voids. The harder you pack it the more stable it will be. I have or will have individual posts to instruct you how to shape shower floors, etc. This one is strictly to describe the proper recipe for your mix.

A couple of companies also make a mix specifically for shower floors and mud beds. I’ve only used one and it worked quite well. Just follow the mixing instructions on the bag and start with the minimum amount of water they suggest and work up from there.

When set (about 24 hours) the mud bed will be a perfectly suitable substrate for your tile installation. It will be sandy on the top. You can scratch it with your fingernail – stop doing that! It’s normal. I understand it’s counter-intuitive, but it really is normal.

Although you may have been led to believe that creating a shower floor from scratch is a very difficult thing to do, it is not. With careful planning and attention to detail you can create a shower that will last for years without any problems. Getting your mud mix correct is at the core of the proper method.

{ 660 comments… add one }

Leave a Comment

Cancel reply

  • Martin

    Hello there,
    I am currently building a house and would like to do electrical in floor heat in my mud, bath and washroom. Will be using ditra heat cable. How thick would I need to make the mud bed and could I just leave it as a finished floor?

    Thank you